Skip to content
Trench ShoringBoxes

Aluminum shoring

Can the excavator lift a lightweight aluminum trench box?

Compare the documented weight of the complete load with the chart for the actual machine and movement. A panel weight alone answers neither question.

Updated November 20, 20263 min read

A 34 lb panel is not the load

The two records meet only at the actual move. A component brochure identifies the item weighed; a machine chart describes the machine in a particular configuration and position. Neither one supplies the missing facts on the other side. [3] [4] [5]

Comparison of the documented complete suspended load with the chart for the identified machine, configuration and position; no lift method or capacity is shown.Load recordWhat is suspended, withdocumented weights andinclusions.Machine chartWhich machine,configuration and workingposition it covers.
What is suspended and what the machine chart covers.

GME’s Build-A-Box brochure lists the BAB-2 panel at 34 lb and the 24-inch BAB-C2-2 corner end post at 18 lb. One number is for a two-foot-high panel; the other is for one post. Neither describes the assembly the excavator will pick up. “Lightweight” is not evidence that the machine can handle it. [3]

Start with two records: what will be suspended, including its documented weight, and what the chart covers for this machine at each position in the planned move. A unit label identifies the equipment to look up; it does not replace either record. [3] [4] [5]

Compare the suspended load with the machine chart

Identify every part that will hang from the machine, including the assembled shield and suspended gear. Use the chart for the machine’s actual configuration, lift radius and height at pickup and set-down; check its notes for attachments already included or excluded. [3] [4] [5] [6]

The brochure identifies BAB-LE as a lifting lug and refers to factory-supplied lift eyes and the manufacturer’s tabulated data. That is a lead to the Build-A-Box instructions, not authority to choose a connection on another shield. Record the applicable instruction and reconcile it with what is actually present. [3] [2]

Read the chart notes before comparing numbers

For a concrete example, Caterpillar’s non-current 2016 303.5E CR GN1 entry specifies a standard stick and says bucket weight is not included. It illustrates why the word “capacity” without the header and notes is incomplete. It is not a chart for the machine on your site. [6]

Bobcat describes lift-point height by reference to the bucket pivot pin, not the bottom of the object. Its guidance assumes a flat, level working surface. Record the actual geometry and surface; if the planned move differs from the chart assumptions, mark the difference for qualified review rather than adjusting a number by guesswork. [5] [4]

Keep exposure controls on a separate record

Mark pickup and set-down areas, the load path, excavation edge, worker access and who controls the exclusion area. OSHA prohibits employees beneath loads handled by lifting or digging equipment and requires them to stand away from vehicles being loaded or unloaded. Employees may not be in a shield while it is being installed, removed or moved vertically. [1] [2]

Without the complete suspended weight and a chart that covers the machine at the planned positions, lifting capacity for this move has not been established. [3] [4] [5]

Sources

  1. 29 CFR 1926.651: Specific excavation requirementsOccupational Safety and Health Administration
  2. 29 CFR 1926.652: Requirements for protective systemsOccupational Safety and Health Administration
  3. Build-A-Box Modular Aluminum Trench Shielding System — features and assemblyGriswold Machine & Engineering / Arcosa Shoring Products
  4. Finding Your Excavator Lift CapacityCaterpillar
  5. Compact Excavator Safety 101: Calculating Lift CapacityBobcat Company
  6. Cat 303.5E CR Mini Excavator specificationsCaterpillar