Skip to content
Trench ShoringBoxes

OSHA & safety

Who Is Responsible for Trench Safety When Several Crews Share a Site?

How competent-person authority, engineering decisions and coordination between employers fit together on a trench job.

Updated November 20, 20264 min read

Which work falls under the excavation standard?

The federal excavation standard reaches further than some crews assume. It applies to all open excavations made in the earth's surface, and its definitions include trenches as excavations. A trench is a narrow type of excavation, generally deeper than it is wide, whose bottom width does not exceed 15 feet (4.6 m); an excavation narrowed to that dimension by installed forms or structures counts as a trench too. That means trenching work can fall under the standard's requirements even when the opening is not called a trench on the plan. [1]

Who can act on a hazard?

OSHA defines a competent person as someone who can identify existing and predictable hazards in the surroundings or in working conditions that are unsanitary, hazardous, or dangerous to employees, and who is authorized to take prompt corrective measures to eliminate them. Both halves carry weight. A name on a contact sheet without authority to halt work or change a method leaves the designation unfinished. [1]

In trenching and excavation work, a competent person inspects the trench, adjacent areas and protective systems before work starts each day, as needed during the course of the shift, and after every rainstorm or other hazard-increasing occurrence; these inspection requirements apply where employee exposure can reasonably be anticipated. Recording the inspection and any change is a safety practice, though the standard does not prescribe a form for it. [2]

When an inspection turns up evidence of potential cave-ins, protective-system failure, hazardous atmosphere, or other hazards, exposed employees must be removed from the trench area until the necessary precautions are taken for that trench. That instruction is the clearest test of whether assigned authority is real, because acting on it can stop production and move cost onto the schedule. [2]

Inspecting conditions does not give a competent person authority to approve an engineering design. The design requirements depend on the protective system and the route selected under §1926.652. [3]

Equipment condition divides the roles again. When materials or equipment for protective systems are damaged in trench work, a competent person examines them and judges whether they remain suitable for continued use. If that person cannot assure they will support the intended loads or are otherwise safe, they leave service and must be evaluated and approved by a registered professional engineer before returning to service. [3]

Equipment and worker preparation

Procurement is largely a documentation exercise. Where a support, shield, or other protective system for a trench comes from a manufacturer's tabulated data, the design must follow all of the manufacturer's specifications, recommendations, and limitations, and any deviation needs the manufacturer's specific written approval. The written material must be at the jobsite during construction and available afterward on request. [3]

NIOSH recommends training workers about the hazards and work practices in a language and at a literacy level they understand. It also recommends preparing a trench emergency action plan before digging begins. [4]

When another crew arrives

An incoming subcontractor needs more than the name of the person who ran yesterday’s briefing. The handoff should tell that crew what has changed, who controls the affected work and how a new hazard reaches someone with authority to act. [2] [4]

A handover links the site contact who communicates hazards and precautions, the arriving employer who identifies affected work, and the competent person who evaluates changed conditions.123Site contactCommunicate the trench location, hazards andprecautions.Arriving crewIdentify where its work or vehicles change theplan.Competent personAssess the changed exposure and act on hazardsfound.
What crosses the boundary between two crews.

NIOSH recommends briefing subcontractors arriving at a trench job on the hazards and precautions that affect their work. A crew arriving for a delivery may not have heard the excavation crew’s morning briefing. [4]

Utility coordination runs on its own timetable. The estimated location of underground installations must be determined before an excavation is opened, and utility owners or companies must be contacted within established or customary local response times and asked to establish locations. As digging approaches the estimated position, the exact location must be determined by safe and acceptable means, and the installations protected, supported, or removed while the excavation is open. [2]

The rules include a fallback. If a utility cannot respond within 24 hours, unless state or local law allows longer, or cannot establish exact location, the employer may proceed with caution using detection equipment or another acceptable locating method. [2]

Access and egress form another shared safety responsibility. Egress requirements apply in trenches 4 feet (1.22 m) or deeper: a stairway, ladder, ramp, or other safe means of egress must be placed so workers travel no more than 25 feet (7.62 m) laterally. Structural ramps used only by employees are designed by a competent person; ramps used for equipment access are designed by a competent person qualified in structural design and built to that design. [2]

Clients sit in the same chain. NIOSH recommends that owners and clients insist on trench safety practices when commissioning work and put trench safety into bid documents and contractor qualifications, placing the expectation upstream of the crew that digs. [4]

Reporting a change

NIOSH advises workers to alert the competent person to signs of a problem with the protective system. An arriving crew needs to know whom to contact and which hazards and precautions affect its work. [4]

Sources

  1. 29 CFR 1926.650: Scope, application, and definitions applicable to this subpartOccupational Safety and Health Administration
  2. 29 CFR 1926.651: Specific excavation requirementsOccupational Safety and Health Administration
  3. 29 CFR 1926.652: Requirements for protective systemsOccupational Safety and Health Administration
  4. Preventing Worker Deaths from Trench Cave-ins (NIOSH Workplace Solutions 2011-208)CDC and NIOSH