Start with the exposure
A shield addresses cave-in exposure inside it; it does not support an endangered adjoining building. An access ladder provides a way out; it does not protect someone walking past the end of the shield. Start with the work position and the hazard, rather than the contents of the truck. If mobile equipment approaches the edge without a clear, direct view, a warning system is needed. Workers exposed to public vehicular traffic need high-visibility garments. [1] [2] [3]
In trenches at least four feet deep, stairs, a ladder, a ramp or another safe means of egress must be within 25 feet of lateral travel. Where people or equipment must cross an excavation, a walkway is required; guardrails are required when the walkway is six feet or more above a lower level. A way out and a crossing serve different purposes. [1] [2] [3]
Air, rescue and water precautions
A meter tests the air. It does not control the exposure or provide the rescue equipment needed where a hazardous atmosphere exists or may reasonably be expected to develop. [2]
Before entry into an excavation more than four feet deep, atmospheric testing is required where oxygen deficiency or a hazardous atmosphere exists or could reasonably be expected. Where hazardous atmospheric conditions exist or may reasonably be expected to develop, appropriate emergency rescue equipment must be readily available and attended when in use. The harness and separately attended lifeline provision concerns employees entering bell-bottom pier holes or similar deep, confined footing excavations. [2]
Atmospheric testing, controls and rescue readiness are separate decisions. A test instrument is not ventilation, and ventilation is not rescue equipment. Likewise, employees must not work where water has accumulated or is accumulating unless adequate precautions protect them. Merely listing a pump cannot show that those precautions are in place. [2]
Design documents belong with the equipment
The applicable design establishes the shield’s configuration and limits. When using manufacturer’s tabulated data, departures require the manufacturer’s specific written approval. Owning all the listed parts does not establish that they belong together. [2] [3]
What the inventory cannot tell you
Where employee exposure can reasonably be anticipated, the competent person inspects the excavation, adjacent areas and protective systems before work, as needed through the shift and after rainstorms or other hazard-increasing events. [2]
If that inspection finds evidence of possible cave-ins, protective-system failure, a hazardous atmosphere or another hazardous condition, exposed workers must be removed until the necessary precautions are taken. [2]
Material condition is a separate safety gate. Protective-system materials and equipment must be free of damage or defects that could impair function, and manufactured items must be used and maintained consistently with the manufacturer's recommendations. Damaged materials are examined by a competent person; if that examination cannot assure they will support the intended loads or are otherwise safe, they are removed from service and need a registered professional engineer's evaluation and approval before returning. [3]
Sources
- 29 CFR 1926.650: Scope, application, and definitions applicable to this subpartOccupational Safety and Health Administration
- 29 CFR 1926.651: Specific excavation requirementsOccupational Safety and Health Administration
- 29 CFR 1926.652: Requirements for protective systemsOccupational Safety and Health Administration