Skip to content
Trench ShoringBoxes

Steel shoring

Following a Steel Trench Box from One Job to the Next

A unit history links a particular shield to its hardware, design documents and damage decisions without confusing them with inspections at the next excavation.

Updated November 20, 20263 min read

Keep one record per steel box

When a steel box changes jobs, its configuration, restrictions and inspection findings should travel with it. Start with the identifier on the unit, not the fleet count. Use the same identifier for the box in the yard, the document that governs its use and every dated finding. [2] [3]

Identify the box and its configuration

Keep the unit identifier with the panel, spreader and keeper details and the applicable drawing. When a box changes hands, the next custodian can distinguish the configuration on that drawing from the hardware delivered. [2] [3]

Match the sheet and the hardware

Pro-Tec Equipment, one named manufacturer example, points users to its serialized specific tabulated data and the certification sheets for its steel trench shields. In that model, the governing document attaches to the serialized unit, not the product family; whether a sheet applies to a particular steel trench box is for that manufacturer to answer, not something a fleet manager should infer. [3]

Pro-Tec describes both four- and five-pipe arrangements. The number of pipes on a neighboring box does not tell you which spreaders, pins or keepers belong on this one. Compare the fitted assembly with the specific certification sheet; keep a mismatch visible even if a substitute fits. [3]

Under the manufacturer’s tabulated-data option, follow all specifications, recommendations and limitations. A deviation requires the manufacturer’s specific written approval. Keep the written data and any approval at the jobsite during construction of the system. [2]

Continued use and return after removal

A fleet number follows a box between jobs; the previous excavation inspection does not. If damage took the box out of service because the competent person could not assure its suitability, its next custodian needs the engineer’s evaluation and approval, not just a repair receipt. [1] [2]

The site inspection concerns the excavation at the time of exposure. The fleet record follows the damaged unit and retains the basis for a continued-use or return decision.ExcavationinspectionSite, shift, conditionsand action on workerexposure.Unit damage recordUnit ID, damage finding,disposition and approvalif needed.
Two different records travel on different terms.

Where employee exposure can reasonably be anticipated, the competent person inspects the excavation, adjacent areas and protective systems before work daily, as needed during the shift, and after rainstorms or other hazard-increasing events. If a hazard is found, remove exposed employees until the necessary precautions have been taken. The unit log does not replace those inspections. [1]

  • Continued use: when protective-system equipment is damaged, the competent person examines it and evaluates suitability for continued use. Record the finding and its basis when that person can assure the equipment will support the intended loads and is otherwise safe.
  • Removed from service: if the competent person cannot give that assurance, remove the equipment from service. It cannot return until a registered professional engineer evaluates and approves it. Record the approval reference rather than treating a completed repair or a new assignment as clearance.
[2]

Reassign the box without losing its restrictions

A steel box that suited one trench may not suit the next trench of a different depth or length. Shield systems must not be loaded beyond their design, and installation must restrict hazardous lateral movement. A deeper excavation, different soil or heavier surcharge is a prompt to check that box's documented limits, including whether the manufacturer's data covers the full depth of the new trench; a documented limit that is less than the new depth stops the assignment rather than carrying over. [2]

Sources

  1. 29 CFR 1926.651: Specific excavation requirementsOccupational Safety and Health Administration
  2. 29 CFR 1926.652: Requirements for protective systemsOccupational Safety and Health Administration
  3. Pro-Tec Pro Series steel trench shields — selected document and spreader contextPro-Tec Equipment