Skip to content
Trench ShoringBoxes

Manhole boxes

Four-wall manhole box: check the chamber, pipe openings and exit route

Compare the chamber, pipe joints and route to the exit with the inside of the four-wall box shown on the supplier’s drawing.

Updated November 20, 20262 min read

Will the chamber and fittings fit?

Compare the measured chamber and fittings with the proposed box drawing at the same scale and orientation. Locate each pipe opening by face and elevation. Include the spreaders and the space a worker needs to reach the exit. [3] [1] [2]

For example, a straight pipe barrel may align with the cutout but its bell may extend beyond the edge. A chamber may fit between the panels but leave the ladder on the far side of a spreader. Mark the actual interference and refer it back with the drawing; a check mark against nominal box width would miss both. [3] [1] [2]

Make sure the quoted layout is the one being compared

Four walls can enclose the chamber without providing an opening where the pipe enters. This solid-wall example gives you a useful question for the supplier: which wall on the quoted drawing has the cutout, and does that opening clear the fitting as well as the pipe barrel? [3]

Four-sided steel manhole box
Four enclosed sides; pipe openings depend on the quoted unit.

Trench Shoring Company’s steel-shield literature describes manhole boxes with four-wall protection and either solid sides or cutouts at the bottom. By contrast, Conquip calls its Manhole Box a two-sided trench lining support system. “Manhole box” alone does not identify the sided layout or even the protective function. [3] [4]

Ask the supplier to identify the precise unit and show the inside faces, openings, spreaders and access arrangement on its drawing. A quote identifies what is offered. Before use, match the proposed assembly and field conditions to the governing technical data; a catalog sketch or quote is not written approval to change a wall, opening or spreader. [3] [2]

Check the route, not just the ladder location

Access and egress are not solved by the box alone. In trenches at a four-foot depth or more, US federal rules require a stairway, ladder, ramp or other safe means of egress placed so that no employee travels more than 25 feet laterally to reach it. In a four-sided layout, the practical question is how a worker moves from the protected work area to that egress point. Plan access before installation, including access equipment and lifting equipment needs. [1]

The shield provisions add two conditions: employees must be protected from cave-in hazards when entering or exiting areas protected by the box, and employees are not allowed inside it during installation, removal or vertical movement. Plan the route from the installed box to the egress point with the same care as the box itself. [2]

Sources

  1. 29 CFR 1926.651: Specific excavation requirementsOccupational Safety and Health Administration
  2. 29 CFR 1926.652: Requirements for protective systemsOccupational Safety and Health Administration
  3. Steel Trench Shields & Manhole Boxes literatureTrench Shoring Company
  4. Manhole BoxConquip Engineering Group